Especially Roofing
Flat Roofs by Especially Roofing
5 Star Rated on Checkatrade

Flat Roofs in Brough

A new flat roof over your extension, garage or dormer, rebuilt from the deck and matched to its use.

  • Felt, EPDM or GRP
  • Edges fixed against wind
  • Warm roof insulation

Get a quote for flat roofs in Brough

Fill out the form below, and we will get back to you swiftly.

Step 1 of 2

Flat Roofs in Brough

Picking the right covering for a flat roof that takes the weather

Most flat roofs over garages and extensions announce their decline. The felt crazes and blisters, trims start to rattle in a strong wind, and puddles linger for days after the rain. By then the covering, or the boarded deck under it, is usually worn out. We rebuild from the deck: soft boards come out, falls are set so water drains to the outlet, and, where heights at walls and doors allow, insulation goes above the deck as a warm roof.

You have three coverings to weigh up. Torch-on felt is laid in bonded layers and is often the lowest-cost route. EPDM rubber arrives as a single large sheet, so joins are few, and we lay it as certified RubberCover installers. GRP fibreglass is laminated in place by us as approved Cure It installers and sets hard enough to walk on. Our VELUX approval also means a lantern or skylight can be built into the new roof.

Flat Roofs project completed by Especially Roofing
Brough

Flat roofs on Brough homes and the wind along the estuary

Edges matter more than usual on a flat roof in Brough. Wind moving along the Humber can get under a loose trim or an unbonded corner and peel a covering back, and once it lifts, rain follows. When we lay a new roof here, the trims, upstands and drip details get careful attention, because a secure perimeter does more to keep the covering in place than anything in the middle of the roof.

The large housing developments of recent decades have brought plenty of garages, porches and single-storey extensions with flat roofs, many of them simple shapes that suit EPDM rubber well. Older village houses can have flat roofs over rear additions or dormers, often in felt that has been patched several times. If you want to step out onto the roof, GRP is the better choice. Shops and commercial units in the town follow the same survey and quote.

What your flat roof quote covers

  • Strip-off of the old covering and waste removal
  • Decking checked and replaced where rotten
  • Warm roof insulation option where it fits
  • Falls set towards outlets and guttering
  • New edge trims, upstands and drip details
  • Roof lantern or VELUX skylight fitting
Drone view over a row of finished roofs on a Hull street
Especially Roofing inspection drone beside pallets of new roof tiles
Grey tiled hipped roof seen from above after replacement
Free Drone Inspections

See your roof from above before you decide

Most roof problems cannot be seen from the garden. Our drone survey gives you clear pictures of the tiles, ridge, valleys, chimney and guttering, so you can see the damage we are talking about and understand why the work is needed.

It is free and there is no obligation. If the roof is sound, we will tell you so. If it needs work, the images sit alongside your written quote, and they are useful if you are making an insurance claim for storm damage.

How It Works

How your flat roof job runs, step by step

Why Choose Us

Why choose Especially Roofing for flat roofs in Brough?

Rated 10/10 on Checkatrade

What our customers say

Reviews from homeowners and businesses we have worked for around Hull.

FAQs

Flat roof in Brough: your questions

Can wind really lift a flat roof?

It can lift a poorly secured one. Wind passing over a flat roof creates suction, and if a trim has worked loose or a corner was never fully bonded, the covering can start to peel. Exposed homes near the estuary see more of this. A new roof with sound trims, upstands and bonding at the perimeter stands up to it far better, and the drone shows where an existing edge has started to lift.

Which flat roof system suits a garage on a newer development?

A plain garage roof is often a good candidate for EPDM rubber, since one sheet can usually cover it with hardly any joins. If budget leads, torch-on felt tends to be the most economical. For a roof that will be walked on or used for storage, GRP fibreglass handles foot traffic better. Your quote lays the options out side by side so you can compare them.

Can my extension roof be insulated as part of the job?

In many cases. A warm roof adds insulation boards on top of the deck, so the finished surface sits a little higher than before. What usually limits it is the height left below an upstairs sill, at a door threshold or where the roof meets the house wall. Those are measured during the survey, and you know whether a warm roof fits before the quote arrives.

Can a roof lantern go in when the flat roof is replaced?

Yes, and the rebuild is the best moment for it. As VELUX-approved installers we fit roof lanterns and skylights, framing the opening into the new deck and taking the covering up the lantern upstand so it stays watertight. Adding one later means cutting into a finished roof, so if you are considering more light in the room below, mention it at the survey.

How long do flat roofs last?

It varies with the covering and with how well water drains away. EPDM rubber and GRP fibreglass usually give longer service than torch-on felt, but any flat roof ages faster where water ponds or the deck has softened. On a windy site, an edge left to lift will also cut its life short. Good falls and secure trims give a new covering the best start.

What are flat roofs made of?

Most have a timber deck fixed across joists, with insulation boards on top where it is built as a warm roof. The waterproof layer goes over that, and we lay three types: torch-on felt in layers, a one-piece EPDM rubber membrane, or GRP fibreglass laminated in place. Trims, upstands and drip edges complete the perimeter, an important detail on wind-exposed Brough roofs.

Do solar panels work on flat roofs?

They can, usually mounted on frames that tilt them towards the sun. The roof beneath needs to be sound, able to carry the added load, and not close to the end of its life, since taking panels off later to re-roof adds cost. Frames must also be fixed to resist wind, which matters near the estuary. If your roof is tired, we can renew it before whoever fits the panels begins.
Get In Touch

Can’t find the answer you’re looking for?

Get in touch with the team today.

Call NowGet Your Quote