Especially Roofing
Flat Roofs by Especially Roofing
5 Star Rated on Checkatrade

Flat Roofs in Patrington

Garage, extension and dormer roofs covered in felt, rubber or fibreglass, matched to how each space is used.

  • Felt, rubber or GRP
  • Warm roof insulation option
  • Roof lanterns fitted

Get a quote for flat roofs in Patrington

Fill out the form below, and we will get back to you swiftly.

Step 1 of 2

Flat Roofs in Patrington

Picking the right covering for the room underneath

A flat roof is rarely truly flat. It needs a gentle fall to carry rain to the gutter or outlet, and a covering that stays watertight at every edge, upstand and joint. Our three systems are torch-on felt, EPDM rubber fitted under our RubberCover certification, and GRP fibreglass, for which we are Cure It approved. Each suits different jobs, so the choice comes down to the shape of the roof, how much detailing it has and whether anyone will walk on it.

A free drone flight shows the roof from above, and the deck, trims and outlets are then checked by hand, so your written quote is built on the roof's actual state. A chilly room underneath can often be helped by a warm roof, with insulation laid on top of the deck, though only where raising the roof level will not clash with door heads, windows or flashings. As VELUX-approved installers, we can also fit roof lanterns and skylights to bring daylight into an extension.

Flat Roofs project completed by Especially Roofing
Patrington

Flat roofs on Patrington extensions, garages and dormers

If your cottage in Patrington has been extended at the back, the single-storey addition is often where a flat roof sits. Where the extension meets the original wall, the upstand and flashing carry a lot of responsibility, and a failure there can show as damp on the old brickwork rather than on the new ceiling. Bungalows tend to have flat roofs over garages or side extensions, while some newer homes have them over porches or dormers, each with its own edges and outlets to get right.

With open land all around, rain on a flat roof can be driven by the wind towards one side, so outlets and falls need to be right or water collects where it cannot drain. Water still lying a day after rain points to a deck that has dropped between joists, or to falls that were too shallow from the start. When we replace a roof like that, soft boards are renewed and firring pieces build in a proper fall before the new covering goes down, so the rain has somewhere to go.

What your flat roof quote covers

  • Strip-off of the old covering and waste removal
  • Decking checked and replaced where rotten
  • Warm roof insulation option where it fits
  • Falls set towards outlets and guttering
  • New edge trims, upstands and drip details
  • Roof lantern or VELUX skylight fitting
Drone view over a row of finished roofs on a Hull street
Especially Roofing inspection drone beside pallets of new roof tiles
Grey tiled hipped roof seen from above after replacement
Free Drone Inspections

See your roof from above before you decide

Most roof problems cannot be seen from the garden. Our drone survey gives you clear pictures of the tiles, ridge, valleys, chimney and guttering, so you can see the damage we are talking about and understand why the work is needed.

It is free and there is no obligation. If the roof is sound, we will tell you so. If it needs work, the images sit alongside your written quote, and they are useful if you are making an insurance claim for storm damage.

How It Works

How your flat roof job runs, step by step

Why Choose Us

Why choose Especially Roofing for flat roofs in Patrington?

Rated 10/10 on Checkatrade

What our customers say

Reviews from homeowners and businesses we have worked for around Hull.

FAQs

Flat roof in Patrington: your questions

Why does water sit on my garage roof after rain?

Water that sits usually means too little fall, or a deck that has dropped between joists so rain gathers in the hollows. Lying water ages any covering faster and will exploit even a hairline split. Clearing a blocked outlet sometimes cures it. If the deck itself has dipped, the lasting fix is to strip the roof, renew soft boards and add firring pieces to create a proper fall.

Can a roof lantern go into my flat roof extension?

In many cases, yes. We are VELUX-approved for lanterns and skylights. A re-roof is the easiest time, since the opening is framed and the fresh covering is dressed up around the kerb in the same job. An existing roof can take one too. The joists and deck are checked before anything is agreed, and you hear plainly if your roof will not suit.

Should I patch the felt on my extension or replace it?

Patching makes sense when the covering is mostly sound and the fault is local, such as one split, a lifted edge or a single blister. Once felt has crazed across its surface, shed its mineral finish or been patched again and again, new repairs tend to fail at the joins. Seeing it from the drone and on the roof itself tells us which you have, and where both routes are sensible, both are priced.

Is torch-on felt still a good choice?

It can be. Modern torch-on felt is built up in layers bonded with heat, and it copes well with busy roofs that have plenty of upstands and outlets. EPDM rubber is usually laid in one sheet, so there are hardly any joins, while GRP fibreglass sets into a rigid, jointless skin. The best fit comes down to the roof's shape, what it is used for and what you want to spend, and the pros and cons are talked through first.

How long do flat roofs last?

Two things decide it: the system, and how well the roof sheds water. Of the three, felt usually gives the shortest service, with EPDM rubber and GRP fibreglass tending to outlast it by some way when they sit on a sound deck that drains. Standing water, regular foot traffic and poorly finished edges all shorten that. On exposed ground around Patrington, well fixed edge trims help any covering go the distance.

What are flat roofs made of?

Underneath the covering is a deck, usually timber boards or sheets laid over joists, sometimes with insulation above it in a warm roof build. On top goes the waterproof layer. That layer might be torch-on felt, heat-bonded in layers, EPDM rubber laid as one synthetic sheet, or GRP fibreglass, where resin and glass matting are applied wet and set hard. Edge trims, upstands and outlets complete the roof, and they are where most leaks begin.

Do solar panels work on flat roofs?

They can, provided the roof underneath is ready for them. The covering should be sound, because lifting panels later to repair it adds cost and disruption. Underneath, the joists and deck have to bear the added weight, and the mounting frames need anchoring or ballast so gusts across open ground cannot shift them. A covering that is already tired is best replaced before any panels go up. Whoever fits the panels is the one to confirm those details.
Get In Touch

Can’t find the answer you’re looking for?

Get in touch with the team today.

Call NowGet Your Quote