Especially Roofing
Flat Roofs by Especially Roofing
5 Star Rated on Checkatrade

Flat Roofs in Flamborough

Re-cover a dormer, garage or extension roof in a system chosen and fixed for an exposed coastal site.

  • EPDM, GRP or torch-on felt
  • Warm roof insulation option
  • Edges and trims renewed

Get a quote for flat roofs in Flamborough

Fill out the form below, and we will get back to you swiftly.

Step 1 of 2

Flat Roofs in Flamborough

Flat roofs that hold together when the wind gets at the edges

Plenty of homes have a flat roof somewhere, even if it is only over a porch, a bay or a back extension added to a bungalow years after it was built. Re-covering one starts with stripping the worn layers and testing the deck underneath. Soft or rotten boards are swapped out, the falls are corrected so rain drains to the outlets rather than ponding, and then the new waterproof layer goes down with fresh trims and upstands.

Three systems are on offer. Torch-on felt is usually the lowest-cost route for a straightforward roof. EPDM rubber comes as a single wide sheet, so a plain roof ends up with almost no joins. GRP fibreglass sets rock hard and jointless, which helps on roofs with awkward details or regular foot traffic. Especially Roofing holds RubberCover certification and Cure It approval, and adds warm roof insulation where the heights allow it.

Flat Roofs project completed by Especially Roofing
Flamborough

Why edges and joins come first on an exposed flat roof

Rain is only part of the challenge for a flat roof in Flamborough. Wind blowing across a flat surface creates suction, and on a headland that pull can be strong, so the perimeter is where a covering is most likely to start lifting. Once an edge peels, gusts get underneath and rain follows. Firmly bonded membranes, secure edge trims and well-dressed upstands where the roof meets a wall do much of the work of keeping it in place.

Dormers on older cottages tend to be small and fiddly, with cheeks, corners and a junction against the main slope, which is where GRP fibreglass can be a good fit. A long garage or bungalow extension with a plain shape often suits a single sheet of EPDM. Salt air is worth thinking about at the perimeter as well, since metal trims and fixings near the sea can corrode over time, so the trim to be used is set out on your quote.

What your flat roof quote covers

  • Strip-off of the old covering and waste removal
  • Decking checked and replaced where rotten
  • Warm roof insulation option where it fits
  • Falls set towards outlets and guttering
  • New edge trims, upstands and drip details
  • Roof lantern or VELUX skylight fitting
Drone view over a row of finished roofs on a Hull street
Especially Roofing inspection drone beside pallets of new roof tiles
Grey tiled hipped roof seen from above after replacement
Free Drone Inspections

See your roof from above before you decide

Most roof problems cannot be seen from the garden. Our drone survey gives you clear pictures of the tiles, ridge, valleys, chimney and guttering, so you can see the damage we are talking about and understand why the work is needed.

It is free and there is no obligation. If the roof is sound, we will tell you so. If it needs work, the images sit alongside your written quote, and they are useful if you are making an insurance claim for storm damage.

How It Works

How your flat roof job runs, step by step

Why Choose Us

Why choose Especially Roofing for flat roofs in Flamborough?

Rated 10/10 on Checkatrade

What our customers say

Reviews from homeowners and businesses we have worked for around Hull.

FAQs

Flat roof in Flamborough: your questions

Can strong wind lift a flat roof covering?

It can, particularly where an edge or join has already started to come away. Wind passing over a flat roof pulls upwards on the covering, and on an exposed site the effect is stronger. A membrane that is fully bonded to a sound deck, with secure trims and upstands, resists it well. If your roof has a flapping edge or a bubble that moves in the wind, it is worth a look soon.

Which system suits a small dormer roof?

Dormers usually have more corners and joins than open area, so GRP fibreglass is often a strong choice, because it goes on as a liquid and cures without seams around every awkward detail. EPDM rubber can work on a simple dormer too. Torch-on felt involves a naked flame, which calls for extra care close to timber cladding or window frames. The survey looks at the shape before any system is recommended.

Is a warm roof worth adding to a bungalow extension?

Often, if the room below is used every day. A warm roof lays insulation over the deck, beneath the new waterproofing, keeping the room at a steadier temperature and cutting the chance of condensation inside the roof. Whether there is room for it depends on how far the roof can rise at walls, door heads and window heads, and the survey measures those before anything is recommended to you.

Can a roof lantern be fitted when the flat roof is replaced?

Re-covering is the ideal time, as the deck is already open and the lantern's upstand can be built before any waterproofing goes on. Especially Roofing is VELUX approved for roof lanterns and skylights, and the new membrane is dressed up around the frame. On an exposed roof, the seal at that upstand needs particular care, and how it will be finished is spelled out in your written quote.

How long do flat roofs last?

Felt usually gives the shortest service of the three, with EPDM rubber and GRP fibreglass both outlasting it and handling sun and frost well. Workmanship and care count as much as the material. In Flamborough, the edges often decide how long a roof lasts, since a covering that begins lifting in the wind fails sooner. Keep outlets clear, avoid standing water and check the trims after storms.

What are flat roofs made of?

Most sit on a timber deck over joists, often with tapered firring strips to create a slight fall, and a warm roof adds insulation boards above the deck. On top goes the waterproofing: torch-on felt, with several layers melted together; EPDM rubber, one synthetic sheet; or GRP fibreglass, resin and glass matting that sets solid. Trims and upstands close it off around the edges.

Do solar panels work on flat roofs?

Yes, usually on frames that tilt the panels towards the sun. On the roof side, make sure the covering is sound with plenty of life left, because lifting panels later to renew it is disruptive, and confirm the deck can take the extra weight. On the headland, frames must be secured against strong wind uplift. Whoever fits the panels should agree those fixings, and a tired roof is best renewed first.
Get In Touch

Can’t find the answer you’re looking for?

Get in touch with the team today.

Call NowGet Your Quote