Especially Roofing
Damp Proofing by Especially Roofing
5 Star Rated on Checkatrade

Damp Proofing in Sewerby

Find out whether the damp in your home is rain getting in, condensation or something else, then fix the cause.

  • Roof causes traced first
  • Flashings and stacks fixed
  • General damp proofing

Get a quote for damp proofing in Sewerby

Fill out the form below, and we will get back to you swiftly.

Step 1 of 2

Damp Proofing in Sewerby

Knowing which kind of damp you have comes first

Most damp in a home is one of three types. With penetrating damp, rain finds a way in from outside, perhaps through the roof, a gutter, a chimney or a wall. Rising damp creeps upward from the ground into the lowest courses of brickwork. Condensation appears where warm, moist air inside touches a cold surface and turns back to water. All three can stain plaster in similar ways, yet each needs a different fix, so naming the type comes first.

Being roofers, we look at the roof first. Drone footage shows the stack, the lead flashings, the flaunching, the valleys and the guttering in close detail, and a check inside the loft picks up wet timber or staining. When the source is found it gets repaired, be that new lead, fresh flaunching, rebedded tiles or resealed gutters. We also take on general damp proofing, and if a cause falls outside our work, we say so plainly.

Damp Proofing project completed by Especially Roofing
Sewerby

Telling rain damp from condensation in Sewerby homes

In an exposed clifftop home, rain can be driven against walls and roofs from the sea side with real force, so penetrating damp often shows on the wall or ceiling facing the weather and gets worse after a stormy spell. Look for patches that grow after wind and rain and shrink again in dry weather. A gable end, a chimney breast or the ceiling below a valley are typical places for it to appear.

Condensation behaves differently. It tends to appear in cold corners, on window reveals and behind furniture, often with black mould spots, and is usually worst on cold, still days rather than after rain. Bungalows can be prone to it on bedroom ceilings where loft insulation is thin or the eaves are poorly ventilated. If you cannot tell which you are dealing with, a free drone inspection and a look in the loft help rule the roof in or out.

What your damp proofing quote covers

  • Drone inspection of roof, stack and roofline
  • Loft check for staining and wet timber
  • Tracing the likely route of the water
  • Flashing, flaunching and chimney repairs
  • Guttering and downpipe repairs or clearing
  • General damp proofing work where suitable
Drone view over a row of finished roofs on a Hull street
Especially Roofing inspection drone beside pallets of new roof tiles
Grey tiled hipped roof seen from above after replacement
Free Drone Inspections

See your roof from above before you decide

Most roof problems cannot be seen from the garden. Our drone survey gives you clear pictures of the tiles, ridge, valleys, chimney and guttering, so you can see the damage we are talking about and understand why the work is needed.

It is free and there is no obligation. If the roof is sound, we will tell you so. If it needs work, the images sit alongside your written quote, and they are useful if you are making an insurance claim for storm damage.

How It Works

How your damp proofing job runs, step by step

Why Choose Us

Why choose Especially Roofing for damp proofing in Sewerby?

Rated 10/10 on Checkatrade

What our customers say

Reviews from homeowners and businesses we have worked for around Hull.

FAQs

Damp proofing in Sewerby: your questions

How can I tell a roof leak from condensation on a bungalow ceiling?

Timing is a good clue. A leak usually shows after rain, especially wind-driven rain, and often sits in one patch below a particular part of the roof. Condensation tends to appear in cold weather whatever the rain is doing, often near the edges of the ceiling, and frequently brings black mould with it. In the loft, wet felt or stained timber points to a leak. An inspection narrows it down.

Why is only my gable wall damp?

A gable end catches the weather side-on and has little or no overhang to shelter it, so on an exposed home it often takes the worst of the wind-driven rain. Water can get in through a failed verge, a leaking gutter end, a chimney on that wall, or the brickwork itself. The roof-related causes are what we trace and fix, and if the brickwork itself is the culprit, you will hear that plainly too.

Could rusted gutter brackets be causing damp inside?

They can. When an old cast iron bracket rusts through, the gutter sags, water gathers in the low point and spills down the wall instead of reaching the outlet. If that happens in every downpour, the brickwork may stay wet long enough for damp to come through to the plaster indoors. Refitting the guttering on sound brackets, or replacing it with uPVC, stops the water at its source.

Do you deal with damp low down on ground-floor walls?

We take on general damp proofing work, so it is worth a look. Damp at the base of a wall can have several causes, including rising damp, ground or paths built up against the wall, or a leaking downpipe splashing the brickwork. Some of these sit outside the work we do, and if that applies to yours you will be told plainly rather than offered a fix that would not address it.

How much does damp proofing cost?

The cause sets the price. Unblocking a gutter or resealing one joint is a modest task, while new chimney flashings, flaunching or stack repairs usually need scaffolding and more material. If damp in your Sewerby home has two sources, each is dealt with and priced. Any replastering afterwards is separate and best left until the wall has dried. A free drone inspection comes first, followed by an itemised written quote.

What is damp proofing?

Damp proofing means stopping water getting into the fabric of a building and dealing with the harm it has done. For penetrating damp from the roof, it means repairing the flashing, gutter, stack or tiles that let the water in. Rising damp and condensation each need their own approach. Our side of it is finding and fixing roof and roofline causes, plus general damp proofing work where that fits the problem.

How long does damp proofing last?

A repair to the cause lasts as long as the part that was fixed. New lead flashing or renewed flaunching should go on keeping rain out for a good while if it is cared for, and a sound uPVC gutter will not rust. What matters is keeping the roof and roofline maintained, because a blocked gutter or a slipped tile can start the problem again. Any guarantee is confirmed on your quote.

How does damp proofing work?

It works by finding where the water comes from and stopping it there. We look at the damp from indoors first, noting where it sits and when it appears, then trace its probable route outside using the drone and the loft. Once the fault is mended, the wall is given time to dry, and you get advice on any making good or further damp work that might follow.

How long does damp proofing take?

The repair itself is often quick: unblocking a gutter or replacing a short run of flashing can be done in a day, whereas chimney work that needs scaffold takes longer. The drying out is what takes time. Once water stops reaching it, a wall or ceiling can need weeks to dry, and longer in a cold, damp spell. Redecorating too soon can trap moisture, so it is best to wait.
Get In Touch

Can’t find the answer you’re looking for?

Get in touch with the team today.

Call NowGet Your Quote